Housing Rack / Pre-fab House in Berlin

Berlin, Deutschland
The 6-storey “Wohnregal” houses live/work ateliers. It is based on pre-cast concrete elements common in industrial warehouse construction.
Foto © David von Becker
A curtain wall consisting of standard sliding glass doors makes up the eastern and western façades. It allows for the interior to be opened up to its surroundings during spring and summer.
Foto © Tobias Wootton
The open staircase and the elevator are located along the northern façade. Small exterior loggias for each unit occupy the north-eastern and north-western corners of the building.
Foto © Tobias Wootton
The “Wohnregal” offers a wide range of different live/work atelier layouts for an ever-broadening bandwidth of urban life styles. The ateliers vary in scale between 35 and 110 sqm. They are east- or west-oriented, and some include both orientations.
Foto © David von Becker
The guard rails are made of fiber-glass grating. The sliding glass door façade can be opened fully. Small covered exterior loggias occupy the corners of the building.
Foto © David von Becker
Site Plan
ground floor
fifth floor
longitudinal section: The TT-ceilings characterize the interior of the live/work ateliers.
cross section: The pre-cast TT-ceilings span over 12 meter form façade to façade without any structural walls needed on the interior.
exploded axo of pre-cast elements of one floor: pillars, beams, TT-ceilings, walls and stairs
Architekten
FAR Frohn & Rojas Planungsgesellschaft mbH
Standort
Berlin, Deutschland
Jahr
2019

Name of work in English
Housing Rack / Pre-fab House in Berlin

Name of work in original language
Wohnregal

Placement
Shortlisted

Prize year
2022

Year completed
2019 (Year began 2018)

Authors
Marc Frohn (1976 Germany); Mario Rojas (1973 Germany)

Collaborators
Architect: Max Koch, Ultike vandenBerghe, Lisa Behringer, Ruth Meigen, Martin Gioleka, Felix Schöllhorn, Pan Hu, Julius Grün, Erik Tsurumaki, Katharina Wiedwald Structural engineering: Tobias Paasche
Program
Collective housing
Labels
Infill, Linear block

Total area
328 m2

Usable floor area
1087,86 m2

Cost
1498 €/m2

Client
Private

Client Type
private

Map
LatLng: (52.5287107, 13.3334975)

“Wohnregal” houses life/work ateliers. It's based on pre-cast concrete elements common in industrial construction and bridges two challenges. It applies serial construction to save cost and time. At the same time it counters preconceptions that seriality always implies uniformity of the units thus addressing an ever broadening scope of lifestyles. The term Wohnregal translates into “habitable rack”. It is a 6-story structure based on pre-fab concrete elements commonly used in industrial construction. The rack houses affordable ateliers which are renegotiating the relationship of live and work environments. There are two units per floor – oriented east and west. An open staircase along the north façade provides access. The ateliers vary greatly between 35 and 110 sqm. Thanks to the principle of the pre-fab rack spanning from façade to façade without interior structural walls they can each have a different plan layout. Sliding doors appropriated as a curtain wall constitute the east and west façades. They allow for the interior to be opened up during the summer, allowing natural ventilation turning the interior spaces into loggias. The building is situated in a corner lot in Berlin Moabit left unbuilt since the war. “Wohnregal” uses pre-cast concrete elements common in industrial construction. It bridges two contradictory challenges of the Berlin housing market. Pre-fabrication offers cost and time savings thus addressing the rising construction cost. Countering preconceptions that serial construction always implies a standardization of the units themselves, the project offers a wide range of different live/work ateliers for an ever-broadening scope of life styles. The ceilings spanning between the facades without any interior structural support enable this flexibility. Prefabrication in housing has been a century-long story of optimization, and has had a continuous up and down of promises stated and promises broken. The “Wohnregal” takes into consideration this contradictory history of prefabricated construction. It re-appropriates the DNA of the prefabricated warehouse which has taken the approach of optimization to its absolute limits. While exploiting that very economy it also reinterprets its structural openness to introduce a discourse that has been strangely absent in the focus on prefabrication: the complexity and variety of inhabitation. The industrial construction of the “Wohnregal” consists of pillars, beams and TT-ceilings. The latter span from façade to façade economically. All interior walls are built using drywall construction. The lack of any structural members in the interior allows for different layouts an every floor. The construction is very economical (1500 EUR/sqm) and fast (6 weeks for the assembly of the complete prefab structure). The curtain wall consisting of sliding glass doors allows for the interior to be opened up to its surroundings during the spring and summer months, turning the living space into a loggia-like environment. There are no means of mechanical climate control in the building, as the natural breeze creates a comfortable climate even during summer days. The rack structure of the “Wohnregal” offers a great degree of long-term resilience. The interior can be repurposed for different uses in the decades to come. This openness implies a longevity and thus sustainability of the structure. Almost all components of the building have been mechanically connected. In the case of the future disassembly all materials can be separated out and become part of a circular economy.

Dazugehörige Projekte

  • Gebäudeadaptierungen Rathausbereich - Zwentendorf
    maul-architekten zt gmbh
  • FON - Wohnbau und Kindergarten Fontanastraße
    GERNER GERNER PLUS
  • GOLD - Wohnbau Goldberg
    GERNER GERNER PLUS
  • BENE - Wohnbau Benedikt
    GERNER GERNER PLUS
  • PUCH - Wohnbau Puchsbaumgasse
    GERNER GERNER PLUS

Magazin